0
  • DE
  • EN
  • FR
  • Internationale Datenbank und Galerie für Ingenieurbauwerke

Anzeige

Effects of In-Situ Drying–Wetting Cycles on the Stress-Dependent Water Retention Behavior of Intact Loess

Autor(en):




ORCID
Medium: Fachartikel
Sprache(n): Englisch
Veröffentlicht in: Advances in Civil Engineering, , v. 2023
Seite(n): 1-7
DOI: 10.1155/2023/2994986
Abstrakt:

Understanding the effects of in-situ drying–wetting pattern on the stress-dependent water retention curve of intact loess is vital for addressing geotechnical problems in loess regions. The principal objective of this study is to investigate the influence of in-situ drying–wetting on the stress-dependent water retention behavior of intact loess. To meet this objective, six drying–wetting tests were carried out using a suction- and stress-controlled pressure plate extractor. Intact loess was sampled from three different depths: 1.0, 3.0, and 5.0 m. For specimens from each depth, two vertical net stresses (i.e., 0 and 50 kPa) were applied prior to the drying–wetting cycle. Experimental results revealed that the in-situ drying–wetting pattern greatly affected various aspects of the water retention behavior, particularly the hysteresis. The hysteresis of the specimen from 5.0 m is about 82% and 77% larger than that of the specimens from 1.0 and 3.0 m, respectively. This is because the specimen from 5.0 m has some large-size pores (i.e., >400 μm), which were not found in specimens from 1.0 and 3.0 m. These large-size pores enhance pore nonuniformity and hence the hysteresis. Furthermore, specimens from different depths consistently showed a reduction of hysteresis when the stress was increased from 0 to 50 kPa. The reduction is the most significant for a specimen from 5.0 m due to the collapse of large-size pores under compression.

Structurae kann Ihnen derzeit diese Veröffentlichung nicht im Volltext zur Verfügung stellen. Der Volltext ist beim Verlag erhältlich über die DOI: 10.1155/2023/2994986.
  • Über diese
    Datenseite
  • Reference-ID
    10736322
  • Veröffentlicht am:
    03.09.2023
  • Geändert am:
    03.09.2023
 
Structurae kooperiert mit
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine